| Capture Interface IP | Blank (detect) | The local adapter address to capture on. Set it when detection picks the wrong adapter, or to the monitor adapter in a mirror setup. |
| Original Stream Destination IP | Blank | Mirror setups only: the primary camera-facing adapter’s address. Requires Capture Interface IP. |
| Stream Destination Port | Auto | Auto learns the port from the first complete frame. Set it to pin a specific stream. |
| Capture Mode | NIC Miniport Tap (Pktmon) | See Capture Modes. |
| Pktmon Component ID | Auto | Pktmon mode only. The Packet Monitor component of the camera’s network adapter, from pktmon list. |
| Allow Promiscuous Capture | Off | Promiscuous mode only. Authorizes putting the adapter in promiscuous mode. |
| Capture Receive Buffer | Auto | Memory for packets waiting to be processed, 1 to 1024 MiB. Auto starts generous and grows while capture loses packets, within this computer’s memory budget. |
| Raw Frame Queue Capacity | Auto | Complete frames that may wait for processing. Auto holds about two seconds of frames, from 48 to 256, and holds more while frames are dropped for lack of room. |
| Pixel Byte Order | auto | How multi-byte pixel values are decoded. |
| Validation Frames | 8 | Consecutive matching frames required before frames are delivered. |
| Validation Timeout | 3000 ms | How long startup validation may run after frames begin arriving. |
| Traffic Report Timeout | 10000 ms | How long silence may last before a diagnostic, and before an auto-learned port is released. |
| In-Flight Blocks | Auto (8) | Frames assembled at once, 1 to 8. Auto allows the most, so a frame can wait for a resent packet while the next frames arrive. |
| Frame Retention | Auto | How long an incomplete frame waits for its remaining packets, 0 to 1000 ms. Auto starts at 10 ms and waits longer while that recovers late packets. |
| Frame Size Limit | 134217728 bytes | Largest frame accepted. |
| Diagnostic Event Capacity | 256 | Recent events kept for failure reports. |